Title: 4.6 Lab: Hole Wizardry
Course: 3D Modeling (Sandbox) > Section: Module 4: Basic Part Modeling - 16 Hours

Introduction

Knowing how to create holes in your 3D models is very important, because it is something you will do frequently. To create the holes in your model, you will used something called the "Hole Wizard". You will learn how to use the Hole Wizard in the following video, and then you will create some holes for your lab.

Lab Instructions

In a 5" x 5" x 2" model, create the following holes. It doesn't matter which face each hole is in.

1. Counterbore hole for a 3/8" SHCS (Socket Head Cap Screw), normal fit, through all.
2. A hole for an ANSI B18.6.7M M6 flat head screw, close fit, through all.
3. A 11/32" slot, 1-3/8" long, 1" deep.
4. An M10x1.5 tapped hole, 30mm deep with a 15mm x 82 deg. countersink.
5. A tapped hole for a 3/4" pipe, 1-1/4" deep.

Submission

See rubric for submission and grading criteria.

Unless specified otherwise, any and all work on this page is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.