Browse Resources

This video, from Chippewa Valley Technical College, discusses robot simulation. "Running the simulator software, creating a virtual work cell, and adding a virtual robot to the work cell" is covered. RoboGuide is used during the video. This video runs 36:43 minutes in length. Additional modules are...

This video, from Chippewa Valley Technical College, goes over how to define and operate a robot in different joint coordinate modes. What the modes gets used for is emphasized. This video runs 17:58 minutes in length. A related PowerPoint slide deck and additional modules are available to view...

This video, from Chippewa Valley Technical College, demonstrates creating a material handling program. The video discusses specific program points and working with interference points. This video runs 15:02 minutes in length. A related video and more modules are available to view separately.

This video, from Chippewa Valley Technical College, covers refining and documenting a program. The video goes over "working with a program to refine moves, add comments/remarks, and optimize the program." This video runs 17:21 minutes in length. A related video and modules are available to view...

This video, from Chippewa Valley Technical College, goes over uploading the Teach Pendant program from RoboGuide to the actual robot controller. "The video demonstrates making the required adjustments of points, movement types, and verification of desired operation." The video covers the following...

This video, made available by the STEM Guitar Project, was recorded at the Guitar Build Institute held at Aptos Middle School in San Francisco, California in 2018. In the video Alex Moll demonstrates neck scraping and sharpening during electric guitar construction. The video runs 6:40 minutes in...

This video from CUNY Kingsborough Community College describes negative staining. The brief demonstration is described step by step and would be easy to replicate in a laboratory setting. Running time for the video is 1:32.

This video, published by the Nanotechnology Applications and Career Knowledge Support (NACK) Center at Pennsylvania State University, offers an overview of the operation of the Veeco Innova Scanning Probe Microscope (SPM). During the video, presenter Sebastien Maeder from Pennsylvania State...

This webinar, published by the Nanotechnology Applications and Career Knowledge Support (NACK) Center at Pennsylvania State University, provides an overview of optical lithography. During the presentation, Atilla Ozgur Cakmak from Grand Valley State University introduces optical lithography and...

This video from CUNY Kingsborough Community College describes the parts of a micropipette. The demonstrator describes each part of the device and what it is used for. Running time for the video is 2:45.